Canoscan N1240u Canon.com Vista 64

Garden bench, and how to make their own hands

house was built. Garden planted. It remains to make the bench, and sitting on it, just enjoy the sunsets

Materials
1) board thickness of 20 mm (back and armrests) and 40 mm (supporting details) and a width of 150 mm and 80 mm respectively

2) Reiki 20x40 mm back to

3) screws / stainless steel screws to connect the load-bearing parts (4x120), thick parts (4x70), the fine details with a thick (3x45 and 3x65) and the mounting rails (3x25)  

4) Шпатлевка  

5) Грунтовка, водостойкая краска или лак  



Инструменты

1) Pencil

2) Ruler

3) Elbow

4) Compass

5) planer (if necessary)

6) Jig with sawing wood

7) Sandpaper (skin) or sander

8) Drill, Slim Drill for drilling holes for screws and feathers Drill 12 mm (or countersink) to hide the screw heads. Bits, suitable for screws



Порядок действий                                                                                                                         
1. Align and adjust the thickness planers blanks neobstrugannyh boards.

2. Mark up items for cutting wood, Using a paper template for the armrests and bends back benches.

3. Saw parts of wood on the markup, using cuttings jigsaw.

4. Zashpatlyuyte bumps and grind the wooden parts from all sides, using a grinder or a simple block wrapped in sandpaper. Grainy paper gradually. Round the lower ends of the slats to the back benches, the edges of the back and armrests.

5. In places tighten screws or screws, drill holes in wood thin. This will reduce the likelihood of cracking timber. To hide the screw head, use zenkovochnoe drill bit or feathers, with a diameter equal to the diameter of cap screw.







6. Proceed to the assembly Assembly Procedure:



6 (a) Side support for the flooring is fastened by four screws 4x70 to the side screen. Better to do inside mount, that is not screwing the screws into the apron. The same thing happened with the second pillar and the side apron.

get the details attached to the front and rear legs, each with four screws 4x70. Notice
that is attached to the rear foot narrower
part of the apron.

6 (b) Ready-sidewall with front and rear apron are connected to the frame. Use 8 screws 4x120.

screwed to the frame board seat.
To eliminate the vibrations each bar
recommended to mount with four screws
4x70.




6 (a) between the hind legs is attached to the lower support rails of the back. Only two screws 4x70.

6 (d) to the front legs and feet screwed armrests.

6 (e) The armrests are attached to the hind foot (inside legs) screws 3x65.



6 (e) to the rear legs of four screws 3x45 fastened back.

6 (x) between the back and bottom support rails are attached. Use screws 3x25.

6 (d) Mount the rail, rounded down.



7. Zashpatlyuyte cap screws, give the putty to dry and oshlifuyte protruding filler.

8. Primed and paint the bench.

"Gardener"